Search models, users, collections, and posts
NA6/NB1 Miata Valve Cover Caps
IP Report
Print Profile(1)
0.22mm layer, 6 walls, 50% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
102
256
20
6
175
111
Released
Description
Avoid the aggravation of tape and sooth your OCD with these paint caps! They work perfectly to seal off openings while refinishing your valve cover. Before painting, apply a little heat (start at 48*C/110*F) to the tops of the plugs to soften the PLA and give a gently press. I didn't get even a hint of paint creep under the caps.
Fitment was perfect for my NB1 cover and father's NA6 (last pic on dirt floor, desperate measures) with the stainless steel hardware from RSpeed, the caps for your coil pack holes may be oversized. Just use foam on those two since you're not covering for a washer.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (20)