Search models, users, collections, and posts
Gtt Table Lamp
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
12.9 h
3 plates
Open in Bambu Studio
Boost
8
16
0
0
7
0
Released
Description
43cm table lamp, I printed the parts and then glued them with two-component glue (use “dima incollaggio” jig for align the parts).
I did some post production with sandpaper and spray paint filler, then painted with acrylic coloured spray paint.
For the lighting I used an LED chip mounted on an aluminum heat sink.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)