Search models, users, collections, and posts
GIF
Print Profile(3)
PLA - 0.2mm layer, 2 walls, 15% infill
Designer
1.3 h
1 plate
PETG - 0.2mm layer, 2 walls, 15% infill
Designer
1.5 h
1 plate
PLA - Magnetic with American Flag Embossed
1.3 h
1 plate
Open in Bambu Studio
Boost
78
221
42
21
394
314
Released
Description
I designed this for a coworker who wanted a stamp dispenser that would also peel the stamp as you pull the roll. There are 2 pieces that have a snug sliding fit. Thread the empty roll through the top 3 slots as shown and stow the roll inside the base. As you pull the roll it will peel the stamp so that you can grab and stick it. Pictured print is PETG.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (42)