All legs are 60mm in diameter and uses M8 screws with hexhead for attachment to the bed. The different leg lengths to choose from are:

60, 80, 100, 120, 140, 160, 180 and 200mm.

All files are availible both as STL and STEP.

Printing:

Print without supports standing up. Use 20% infill and at least 4 walls for good strength. I printed mine in PLA.

Assembly:

Insert a M8 hex screw into each leg by dropping it into the hole and pulling it out by the thread trough the hole. If the fit isn't snug enough, use a little glue to keep it in place.

The length of the screw should be at least 15mm, how long it really should be depends on your bed. My screws where 40mm long.

If you found this model useful, drop a like! :D

Would you like a different size? Leave me a message.