Search models, users, collections, and posts
BTT HDMI7 V1.2 Holder--必趣HDMI7 V1.2支架
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 20% infill
Designer
4.8 h
2 plates
Open in Bambu Studio
Boost
12
21
8
1
57
12
Released
Description
Content has been automatically translated.
Introduction
Screen Mount Suitable for BTT HDMI7 V1.2, Featuring:
- Mounted on the side of the printer, avoiding installation at the bottom of the printer due to the large screen size, which would be aesthetically unpleasing and even pose a risk of accidental collision and damage;
- Can rotate 180°, facilitating operation from different positions around the printer, aesthetically pleasing and practical;
- Hides the screen cable for a more aesthetically pleasing look;
- Adaptable to printers with 2020 aluminum profile frames, covering almost all mainstream DIY printers;
- Provides STEP files for convenient modifications based on your specific printer.
Main Hardware
- M3x12 Countersunk screws 5pcs;
- M3x12 Round-head screws 2pcs;
- M3x10 Countersunk screws 1pcs;
- M3x8 Round-head screws 10pcs;
- M2x16 Countersunk screws 6pcs;
- M2 Hex nuts 6pcs;
- M3 T-nuts 24pcs;
- Φ5x30 Cylindrical pin 1pcs.
Special Notes
If the screen rotation feels loose, you can add a silicone pad (soft material is better) on one end of the case_holder to increase the screen rotation damping.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)