Search models, users, collections, and posts
4L Container Filament Holder + Humidity Indicator
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.2 h
1 plate
Open in Bambu Studio
Boost
34
123
8
4
159
44
Released
Description
The original design filament holder was too small for the food containers I have. I therefore redrew it in Fusion to fit my 4L food containers (https://amzn.eu/d/iivlmhY) and added a hole for a humidity sensor (https://amzn.eu/d/hCdHELs) plus a hole at the other end for a 4mm push fit connector (https://amzn.eu/d/bwMo1Bf). It works with the original filament roll axle from this design: https://wiki.bambulab.com/en/filament-acc/acc/sealed-box
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)