Meta Quest 3 controller stand
Remixed by
Meta Quest 3 controller stand
Remixed by
Boost
28
58
20
Print Profile(2)
0.2mm layer, 23 walls, 60% infill
Designer
3.6 h
1 plate
0.2mm layer, 2 walls, 15% infill
3.4 h
1 plate
Open in Bambu Studio
Boost
28
58
20
2
140
133
Released
Description
Controller stand for me to use at my desk. Nice when using mouse and keyboard in VR but need them around.
Comment & Rating (20)
All
Print Profile
0.2mm layer, 23 walls, 60% infill
passt. sieht gut aus
(Edited)
0
Reply
Print Profile
0.2mm layer, 23 walls, 60% infill
Came out great and fits the controllers perfectly. If there was anything to change, I would say make the base a bit thinner as it doesn't need to be thst thick so could save some plastic.
0
Reply
Print Profile
0.2mm layer, 23 walls, 60% infill
Good Design 👍🏻
(Edited)
0
Reply
Print Profile
0.2mm layer, 23 walls, 60% infill
solid!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ideal fit
0
Reply
Print Profile
0.2mm layer, 23 walls, 60% infill
Very good! Sturdy, looks good and fits controllers well.
Printed in PLA +
0
Reply
Print Profile
0.2mm layer, 23 walls, 60% infill
Forgot to set down the infill...design works! thanks
(Edited)0
Reply
Print Profile
0.2mm layer, 23 walls, 60% infill
0
Reply
Print Profile
0.2mm layer, 23 walls, 60% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Remixes (2)
Related Models
© 2024 MakerWorld