Very Pretty!

Kudos, they look great with the 0.2. Printed a few sizes and colours. Supports were needed as they get a little bigger to keep them on the bed

Good with some changes - I had issues getting it to stay on the plate without supports, so I ended up remixing it with a little bit larger base so there was more surface area on the build plate. The rose model is great though and the earrings are pretty!

These are so cute but I cannot get them to adhere to the print bed on my A1 mini. I’m using the same print parameters listed and am cleaning the bed with soap/water and ipa. Any advise?

Super cute! Had to use a lot of supports to get it to stick :D

NICE

The details are incredible, a superb use of the 0.2mm nozzle !

Dear designer, would you care to share which filament you used that had the glitter?

Dear designer, does your filament have glitter in it? Do you care to share it please?

melhor com um hotend de 0.2 mm. não consegui que a impressão ficasse na cama.