Bridging Test - 5 to 100 mm

with default profile, sag begins at 40 mm

tried with different bridge speeds

1. Try I sent it via my phone and made no settings adjustments My AMS shows too high humidity the printer is also in the living room All gaps were printed almost horizontally From a 4mm bridge I get threads that have no function and hang down But I am impressed that the software simply compensates for that Because despite that it is horizontal at the top 2. Try Changed speed on phone to 50% silent mode Identical result Wow it is really fun

great test! here are my results, not bad I think

Nice Profile! I went on a tangent due too choosing too low temp starting off, but I finally got a good PETG Filament and Process files that now prints good PETG prints. :-)

thx, really helps to set cooling

Changed a few settings, was a good test.

Nice little bridge test. printed it to compare with my new P2S!

Quick and easy print, the hard part is to make it look better 😃

Based on the test print, the bridging performs well at around 10 and begins to sag at around 20