Search models, users, collections, and posts
Gridfinity Silverware Drawer 7x2
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
29
91
6
3
229
73
Released
Description
Using Bambu Studio, I cut the Gridfinity Silverware 6x2 a couple times allowing you to keep the swooping middle section. While this is a bit of a hack, the grid below supports it well. Prints on one plate in under 4 hours on my x1c.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)