Double Cap/Hat Hook

! IMPORTANT !: This hat hook is designed to work specifically with the 3M Command Strip Large WHITE FOAM version (item# 17023P-ES) the same ones in the reference image, if you use any other version, it may not hold onto the wall as intended. 

Update: 04/23/24

I made adjustments to the inner fillets of the hook (and elephants foot compensation on the 3mf), hopefully this will help with some of the fitment issues.

--------------------------------------------

This cap hook is designed for those who have multiple caps and need additional storage. With this hook, you can neatly store multiple caps and have easy access to each of them.

The hook is designed for, and works best with, caps with an open back and have a clasp. Like the below image.

To remove the hook, PRESS the button on the side, then slide the hook upwards.

This hook requires supports, I have uploaded a couple different models, one with supports built-in (must be printed at .20 layer height) and one without. If you are comfortable with your own supports, I recommend you print your own.

Recommended:

• Print with at least 4 wall loops for extra strength
• Use the 3M Command Strip Large WHITE FOAM version (item# 17023P-ES), if you use any other strip it may not hold on to your wall properly. 

Important:

• Supports are required!
• If you print the model with BUILT-IN supports, no additional supports are required.
• If you print the model with BUILT-IN supports, it is best to be printed at .20 layer height
• Install 3M Command Strip on the side that says “3M Here”