Omega Shenron Hueforge Dragon Ball GT (Legends)

Omega Shenron is here!

This is my first hueforge paint so it probably has a lot to improve.

This image is a frame of the mobile game Dragon Ball Legends, from the video presentation of the Ultra Character Omega shenron.

Print Configuration:

Layer Height: 0.08mm

Initial layer height: 0.16mm

Infill: 100%

I reduced speeds just a bit to make sure it prints well.

For filaments I used (not the same as mentioned in hueforge):

PLA Winkle Negro azabache for black

PLA Winkle Violeta Nácar for purple

PLA Winkle Gris ceniza for grey

PLA Winkle Blanco Glaciar for white

This are Hueforge instructions

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 112.79x150mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 1.8mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA PolyLite Pro Dark Purple Transmission Distance: 0.3
PLA BambuLab Tough Gray Transmission Distance: 1.8
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Dark Purple
At layer #7 (0.64mm) swap to Gray
At layer #13 (1.12mm) swap to Jade White for the rest.