Search models, users, collections, and posts
AMS Glass Separation Riser w Front Rim
Remixed by
IP Report
Print Profile(1)
PETG-CF, 0.2mm, 3 walls, 15% infill
Designer
12 h
2 plates
Open in Bambu Studio
Boost
19
61
21
2
162
57
Released
Description
Remix of SpectreGadget's brilliant AMS riser. This adds a rim / lip to the front edge to fully capture the glass top and prevent it from sliding forward without lifting it up. I found that sometimes the glass would sometimes move forward during long prints, possibly due to the combination of the printing shaking about and/ or it not being perfectly level. I also added an additional 0.05mm clearance and shortened each dovetail for a bit easier assembly, but may add a touch more as I still needed a clamp to press things together.
This remix is based on
This source model was used for remixing/sharing before its license was restricted.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (21)