Worx Landroid WR167E - Cutting disc

Cutting disc with 6 blades compatible with

WR167E - Landroid M700 Plus

2025 new model: This is a new version, raised 8 mm compared to the original one. Use this when wheels are worn and you need to compensate for the height of the cut. Or just use this to raise the cut of the grass to 68 mm instead of 60 mm

This is the new version of Landroid with the Hex adapter below the cutting disk. Diameter and total height are the same of the stock cutting disk. Just use M4 standard DIN nuts for securing the blades.

I know that is not 100% 3d printing friendly due to the supports needed but… they are on the face that you don't see so just print with supports under the plate.

Depending on your printer maybe the 3 holes in the middle need to be drilled a bit.

I don't know if it is compatible with M500 or M1000 Landroid 2.0