Snapping Handlebar Mobile phone Clamp - Free 3D Print Model

Search models, users, collections, and posts

Stamos

Hobby & DIY>Sport & Outdoors

IP Report

Print Profile(1)

All

H2D

X1 Carbon

P1S

A1 mini

P1P

X1E

H2D Pro

H2S

P2S

H2C

X2D

A2L

PetG, 0.2mm layer, 2 walls, 15% infill

1.8 h

2 plates

4.3(10)

Open in Bambu Studio

Boost

115

263

506

158

Released

Description

This is a quick snap clamp for your mobile phone. The phone snaps in place with one move.

To connect the moving parts together use small pieces of filament. The base slides into the mounting part and locks with a piece of filament through the small hole. You will also need an M5 allen bolt and a nut to mount it on your handlebar. There are two versions depending on the phone width, and three different mounting options (two for handlebar and one for stem).

Although the clamp snaps firmly, it is advised to use small rubber bands or pieces from tubes (28mm road tubes) at the point where the arms touches phone, to ensure it doesn't slip at all.

Acknowledgments
Handlebar 3d model by Semyon Filippov
Mobile Phone 3D model by sillywilly

From BlendSwap.

Comment & Rating (21)

@matchajoejoe

Print Profile

PetG, 0.2mm layer, 2 walls, 15% infill

great print, no issues

@user_3573290807

how do I get the connecter to the bike and I need a file

The designer has replied

@user_3473442797

There are different types of mount in the folder "Handlebar Mounts"

@user_1851338182

Replying to @user_3473442797 :

how do i get there?

@user_3473442797

Replying to @user_1851338182 :

Where?

@URJEALOUS

would it fit a iPhone 11 with a thick case?

The designer has replied

@user_3473442797

The wide version could hold up to 80 mm. Measure your total phone width and if it is under 80-81 mm it would fit.

@user_3436470610

Nice model. I printed "Handlebar_Mount_low_profile" with 20% infill. Unfortunately, it broke the first time I used it. I'll try it again with 100% infill. My Galaxy A25 fits perfectly in the mount without a case. I'd like a slightly larger version that fits the phone with a case.

The designer has replied

@user_3473442797

Hi. Where did it brake? Can you post photos of the failure? What orientation have it printed? I would like a feedback to improve it if I can. Thank you.

@Ricedude

Print Profile

PetG, 0.2mm layer, 2 walls, 15% infill

i loke how it snaps in to the phone. but the hole was a bit to big to fit on my handle so i but some grip in between it and it Was tight.

@Ricedude

oh i get it now for everyone who didnt: you have to download the stl files so you can choose what to print. without it you will only print the phone holder with out the mount

(Edited)