Knife Sharpening Kit for 2 x 72 Grinder

All Compatible Lightbox Frames & Mounts Available Here!
 

🛠️ Recommended Gear

Check out my Amazon Storefront by clicking here!

Bed Adhesion (Fix First Layer Issues)         Magnets (for optional mounts)

Recommended LED Light Strips     Battery Powered LED Light Strips     Double Sided Tape for Lens: Optional

Custom One-Off Designs Available - CLICK HERE

Printing tips are located at the bottom of this listing

___________________________________________________________________________

This is an actual replacement clamp for the Reeder Products 2" x 72" grinder attachment. I have included the STL for clamp which requires two 4mm threaded heat-set inserts and one 5mm threaded heat-set insert.

The benefit of this setup is no scratches on finished blades without having to cover them in tape.

The other 2 files are the replacement rod and collar (also require a 4mm insert). I have not printed or tried them yet but I am using the clamp on the original rod. The original rod has an end diameter of 9.5mm. If you have a different setup and have the same dimensions this could work for you. If not, you could print a new rod and collar as well.

I recommend printing with 4 walls and 100% infill and use PETG. It took 32 minutes on my Ender 3 KE.

_________________________________________________________________________________________________

Thanks for downloading from Chopper Originals.

If this print earned a spot on your printer and you’re out of Boosts, consider buying me a coffee ☕ to help support future designs and releases.

___________________________________________________________________________________

Affiliate Disclosure
Some links in this listing are affiliate links. As an Amazon Associate, I earn from qualifying purchases at no extra cost to you.

____________________________________________________________________________________

Having issues getting that first layer to flow and stick good? Follow these steps, it helps! ***If using an enclosed printer, be sure to remove the lid and leave door open to avoid heat creep***

If using multiple brands/types of filament, you will need to save each as a Custom Filament setting. Otherwise the settings will change when your colors switch.