klp1 magnet extruder cover Lightweight magnetic extruder cover

There are four versions available, one of them will definitely meet your needs.

The original cover weighs 45g, and the knurled nut cover with three holes weighs 30g.

To prevent the door from hitting, the structural space is extremely tight. Pay attention to the wiring of the small board and ensure the wires are properly routed. It can be installed if you take good care of the wires.

It works perfectly with the KLP1 Three-Nozzle Air Duct that I made.

It can be printed with PLA, but if you plan to keep the enclosure closed for a long time, it is recommended to print it with PETG.

klp1-extruder-cover V4-1   Three holes - knurled nut, both sides 3MM

klp1-extruder-cover V4-2   Three holes - screw direct installation, both sides 3MM

klp1-extruder-cover V4-3   Two holes - knurled nut, both sides 3MM

klp1-extruder-cover V4-4   Two holes - screw direct installation, both sides 3MM

klp1-extruder-cover V4-5   Three holes - knurled nut, both sides 2MM thin wall

klp1-extruder-cover V4-6   Three holes - screw direct installation, both sides 2MM thin wall

klp1-extruder-cover V4-7   Two holes - knurled nut, both sides 2MM thin wall

klp1-extruder-cover V4-8   Two holes - screw direct installation, both sides 2MM thin wall

Note, each file contains three parts and needs to be separated into objects before printing. The two positioning blocks are installed at the original cover screw locations. The positioning blocks are marked with L and R, please pay attention to the difference. The placement method is shown in the picture.

Accessories:

M3 knurled nuts: M3*4.5*5  2 pieces

Neodymium magnets: 3mm*3mm        12 pieces