Search models, users, collections, and posts
Door Stopper
IP Report
GIF
GIF
Print Profile(2)
0.2mm layer, 3 walls, 30% infill
Designer
1.5 h
1 plate
Profile print for A1 Mini 0.2mm layer, 2 walls, 15% infill
1 h
1 plate
Open in Bambu Studio
Boost
144
402
28
7
651
370
Released
Description
Simple doorstop. It is suitable for doors that have the gap on the bottom between 2-3 cm.
Just use doublesided adhesive tape, or other type of adhesive on the pootom of the stopper. Then simly slide the door over. To release the door, just step on the sticking part and move the door.
Print on the side for better durability. I printed mine with 30% infill.
Leave a review or a thumbs up if you like this print
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (28)