Car Seat Gap Filler Storage Caddy - Free 3D Print Model

Search models, users, collections, and posts

squinn

Hobby & DIY>Vehicles

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

Standard Profile, 0.2mm layer, 3 walls, 15% infill

Designer

5.7 h

2 plates

4.7(7)

Open in Bambu Studio

Boost

621

1746

993

580

Released

Description

Make better use of that small gap between your seat and center console by sliding in this nice catch-all tray, which includes a space to hold a soda can at the front. The main part of the tray is sized large enough to adequately hold pens, mobile phones, wallets, etc. - while still being small enough to fit on a 25 cm print bed.

Both a “left” and “right” orientation is provided, and the support piece should be glued to the bottom - flush with the side of the tray. If your vehicle has a larger gap, then print and add on second copy of the support piece. After assembly, simply slide it into place, and enjoy the ride!

Comment & Rating (9)

@EmzBry

Printed fine, but would be better if there was a better attachment method. Either interlocking parts or maybe holes to slide zip ties in order to secure the base. I ended up using a drill in order to secure zip ties since super gluing two flat services together is not the most secure.

@user_458702760

Print Profile

Standard Profile, 0.2mm layer, 3 walls, 15% infill

printed perfect

@user_3694507501

Print Profile

Standard Profile, 0.2mm layer, 3 walls, 15% infill

printed well but supergluing shouldnt be necessary

@otokomatik

Boosted

Print Profile

Standard Profile, 0.2mm layer, 3 walls, 15% infill

nice design

@naufal0azeez

Print Profile

Standard Profile, 0.2mm layer, 3 walls, 15% infill

Thank you for the model!!

@user_3592209820

Print Profile

Standard Profile, 0.2mm layer, 3 walls, 15% infill

It’s working fine so far. I intended it for my wife’s car but ended up using it in my truck. Her seats are too sloped. I don’t mind having to glue it together, but I would feel more confident in it if it had locating pins for both orientation and strength. Ot would be a shame for the glue to fail while holding an opened drink.