Loki crown (Sylvie) - Free 3D Print Model

Search models, users, collections, and posts

3D Lab HN

Props & Cosplays>Masks & Helmets

IP Report

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

A1 mini

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 2 walls, 15% infill

Designer

4.1 h

2 plates

4.5(36)

0.2mm layer, 2 walls, 15% infill

4.9 h

1 plate

5.0(2)

Open in Bambu Studio

Boost

427

928

618

323

Released

Description

Corona de Lady Loki - Variante de Loki - Sylvie Laufeydottir - para cosplay

Comment & Rating (46)

@BRedd84

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Resized and printed to fit my daughter’s head. printed great and had no issues.

The profile uploader has replied

@michaelslh3

I fiddled around a lot to make it work on one plate. a few failures so that everyone else would have a reliable plate. lol

(Edited)

@pxsdaemon

Print Profile

0.2mm layer, 2 walls, 15% infill

Flawless

@HotFix

Print Profile

0.2mm layer, 2 walls, 15% infill

Support Issue:I printed this crown like 8 times before it finally went through "good enough". All the previous attempts the parts kept coming loose off the bed. Glue, no glue, added heat to the bed, nothing seemed to make a difference. On the last attempt I added massive brims and used the strong hybrid supports and even then the very tip (over the nose) part of the main crown had finishing issues. The other parts printed fine but the orientation on the main crown should probably change.

Bed Adhesion Issue

@msanch2

Print Profile

0.2mm layer, 2 walls, 15% infill

@HotFix

I'm now trying my 4th print. This latest one with 15mm brims, 0.1 gap, tree supports with 15mm brims, turning off reduce infill retractions, 70c textured PEI build plate, etc... The sides of the crown are so thin and there is very little for them to stay stuck to the build plate as it starts to connect the crown in the middle. I don't know why others aren't reporting the same. If this doesn't work, I'm going to change the orientation completely because I'm out of ideas.

@HotFix

This time I watched the print fail and it was the actual center V that kept catching on the nozzle and eventually dislodged the support. I'm switching to another brand of gold silk PLA I have in hopes that its better but I don't have high hopes.

@Graysons3dLab

does this glue together or need magnets? of magnets, what’s size?

The designer has replied

@3D_lab.HN

glue

@Graysons3dLab

Replying to @3D_lab.HN :

thanks

@vero_pedo

Print Profile

0.2mm layer, 2 walls, 15% infill

my first attempt was a fail on the supports the left side of the crown fell about 60% of the print i had to start over and it completed, pieces need sanding down and there good to go with some super glue .