Roborock S8 Pro Ultra Dust Bin

Dust Bin for the Roborock S8 Pro Ultra

Dust Bin for the Roborock S8 Pro Ultra

This reusable dust bin replaces disposable filter bags and allows for easy emptying

• The two halves are connected with a 1.75 mm piece of filament, serving as a hinge
• Two clips securely close the container and allow for easy opening and emptying
• The seal is glued into the designated recess
• The filter used matches that of the robot's original dust bin
• The division of the container is at the bottom end
• The container has been optimized and tested for easy use
  

A 1.75 mm diameter piece of TPU filament is inserted into the groove in the lower part of the dust bin of Version 2.1. This filament serves as an additional seal and prevents dust from escaping at the joint, ensuring effective and clean operation of the bin

‼️ If you already own Version 2.0 without a seal, you only need to re-print the lower part to upgrade to Version 2.1

Material recommendation:
Printed from PLA, which in my experience is completely sufficient. The seal is made of TPU

⚠️ Disclaimer: The use of this dust bin is at your own risk. I assume no warranty or liability for damages that may arise from its use

👉 See also my dust bin

Versions

🆕 Version 2.1

✅ Added an additional seal (Version 2.0 and 2.1 are compatible with each other)

🔄 Version 2

✅ Bottom straightened for better fit and stability

✅ Hinge and clips added for easier opening and emptying

🔄 Version 1.0

✅ Original version