banana knife

Seen on MakerWorld

But it's a Print in Place design

I cut it into parts

It can be printed in different colors

I directly pressed the pins in and they fit snugly

For stability, a little glue is recommended

2025/5/27 Update

After reviewing everyone's feedback

The pin design has been updated

making the pins less prone to breaking

2026/2/21 Update

Updated PETG version (original PLA unchanged)

Reduced the tolerance

My own tests show it can be assembled without glue

It can be secured by tapping with a hammer

2026/6/2 Update

The old version's profile has been hidden

because the pins in the old version were prone to breaking

Additionally, there was feedback about the lack of an installation manual

I took some pictures hoping they would be helpful

The pins are intentionally shown in black for distinction