Horizontal Ps5 stand with risers - Free 3D Print Model

Search models, users, collections, and posts

Remixed by

cerberez

Hobby & DIY>Electronics

IP Report

Print Profile(1)

All

P1P

P1S

H2S

P2S

X1E

H2D

H2D Pro

H2C

X1 Carbon

X2D

A2L

0.08mm layer, 2 walls, 15% infill

Designer

9.8 h

2 plates

4.5(8)

Open in Bambu Studio

Boost

128

164

Released

Description

My friend wanted to raise his ps5 up so he could fit an xbox under it with room for air ventilation between them. I gave the model legs. Printed in PETG, it feels pretty darn solid!

NOTE: some people are having trouble getting it to fit. It fits perfectly on my friend's ps5 so I'm assuming there may have been some slight change to the ps5 curvature somewhere along the line. It's not at my house, so I'm not able to check and fix it, sorry!

ps5

entertainment

entertainmentcenter

Comment & Rating (21)

@user_3941646851

Boosted

Print Profile

0.08mm layer, 2 walls, 15% infill

right side on angle not flush

The profile uploader has replied

@gooddogsbrent

where?

@user_3941646851

Boosted

on the right side

@Null_Bar_

Boosted

Had the exact same issue. also Original ps5?

@ManagingLions

Hey, quick question if you don't mind. What's the height measurement of this (aka measurement at top of PS5)? I have a Kallax IKEA shelf unit and am trying to see if it'd fit inside it. Much appreciated for the model regardless!

The designer has replied

@gooddogsbrent

great question! it's at my friend's house, but i'll ask him to measure it to be sure, but until he can do it my rough calculation from the height of the stands at their tallest point and the 4.1" depth of a ps5 says it's about 8.7 inches, well within the (I think) 13 inches of a kallax.

@user_2788810223

Boosted

Print Profile

0.08mm layer, 2 walls, 15% infill

Works great. Since the legs dont connect to each other at the bottom it wobbles a bit. But probably the fact that I have increase the leg length for 10cm to fit xbox series x and some room for air flow is the main reason.

The profile uploader has replied

@gooddogsbrent

connecting legs would be a good idea!

@Null_Bar_

Boosted

Print Profile

0.08mm layer, 2 walls, 15% infill

Not sure which ps5 model this is for, but it's surely not for the original disc model. left side fits somewhat, but the right side does not. printed perfectly otherwise

The profile uploader has replied