Search models, users, collections, and posts
Arduino Uno and Breadboard Holder
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 10% infill, Adaptive Cubic
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
379
990
95
35
1.5 k
834
Released
Description
This model was made specifically for this kit: https://www.elegoo.com/products/elegoo-uno-most-complete-starter-kit. But it can be used for any Arduino Uno and 160mm Breadboard. 3xM3 bolts and 3xM3 nuts is needed to fasten the Uno to the model. 3 spacer rings should be placed between the Uno and the bottom and aligned with the holes.
NB! You need to cut off the tabs on the side of the breadboard!
License
This user content is licensed under a
Creative Commons Public DomainRemixes (4)
Click to see more
Comment & Rating (95)