Cadet Standalone Throttle Knob for Flight Sims
Print Profile(1)
Description
Summary
This is a standalone adaptation of my CadetThrottle Module!
!!!IMPORTANT!!!
There are a few slight changes in this version compared to the module version. PLEASE follow these changes or your knob will not work!
No hole is required since there is no fine adjustment on this component!
CHANGES:
Straw length: 230mm
New potentiometer form factor:
----Travel: 100mm
----Mounting Hole Distance: 120mm
----Slide Shaft Width: 8mm
----Similar to these:
https://www.amazon.com/IIVVERR-Potentiometer-Potenci%C3%B3metro-deslizante-Terminales/dp/B08LDV6FF4/ref=sr_1_4?dchild=1&keywords=100mm+slide+potentiometer&qid=1605547511&sr=8-4
You will also need to drill two additional M3 holes in your mounting surface to align with the 2 M3 holes on the front of the base.
Other than these changes, follow the rest of the build guide here:
https://youtu.be/W6DysglXp-0
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
15%
Filament:
Overture PETG
Black
Notes:
The sheath should be printed thread-side up using a brim to secure it firmly to the build plate. rnrnThe knob and cap should be printed face down with support under the overhang circles. rnrnThe end cap is a rotary joint that prints in place. Use needle-nose pliers to break the joint free.
License
Comment & Rating (2)