Search models, users, collections, and posts

XXL Wago tool box No AMS

Remixed by
IP Report

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
H2D
H2D Pro
H2S
P2S
H2C
X2D
A2L

0.2mm layer, 3 walls, 10% infill
0.2mm layer, 3 walls, 10% infill
Designer
14.4 h
4 plates
4.8(111)

AMS text, 0.2mm layer, 2 walls, 15% infill
AMS text, 0.2mm layer, 2 walls, 15% infill
1.1 h
1 plate
5.0(20)

Open in Bambu Studio
Boost
600
1600
156
154
1.6 k
754
Released 

Description

you have to put 3x6mm screws into the hinges from the inside and put some glue on the screw head.

Comment & Rating (156)

(0/1000)

Print Profile
0.2mm layer, 3 walls, 10% infill
The logo is a bit too dark, but otherwise a great print. Very nice
Show original
2
Reply
its your plastic not a project problem....
(Edited)
3
Reply
Replying to @4tra :
That's certainly possible too, but it's a great piece 👍
Show original
0
Reply
The idea is brilliant. Thank you. But the suggested method of mounting it with screws in such small slots makes me want to smack the author's hands with an engineer's ruler.
2
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Superb results using Bambu Lab PLA Matte on the X1C and P1S! The box is quite large, which should be considered before printing—also, the three clips or lids do not stay closed on their own (not ideal as a transport box, perhaps consider adding magnets) Thank you for the excellent design!
Show original
1
Reply
Dude that looks amazing
(Edited)
1
Reply
perfect printing, thanks
2
Reply
Nice design, just fit on my Prusa Mk4S plate. Fitting the orange levers is a bit tricky, I ended up using 90 degree bent metal (from a metal coat hanger) and hot glued in as there is not much space to put a pin or bolt in. I'd prefer if it had one long rod across the whole design which slotted in all 3 levers.
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 10% infill
I love this print. Screws were a little hard to get in. Now I have a box for all my Wago connectors.
1
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 10% infill
super
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
very gd
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
thx
1
Reply
How do you get the screws in there
Show original
4
Reply
I'll follow this discussion I'm also interested in how to get the screws into these small holes
Show original
2
Reply
I have found a solution for myself 1) The screws are inserted into the rear openings in the lid 2) Slide on and hold the orange “clamps” 3) Turn it over again and use a thin Allen key to guide the screws through the hole and simply push them through (do not screw them in) 4) Apply adhesive to or around the screw heads
Show original
3
Reply