Search models, users, collections, and posts

Dremel organizer with drawers

IP Report

Print Profile(1)

All
A1 mini
P1S
P1P
X1
X1 Carbon
X1E
A1
H2D
H2D Pro
H2S
P2S
H2C
X2D
A2L

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
11.4 h
3 plates
4.8(19)

Open in Bambu Studio
Boost
334
767
32
34
558
227
Released 

Description

This is a small organizer for dremels. 
The top part features holes to store different sized drill bits, sanding disks and other accesories.
The drawers allow you to store spare part, mini wrenches, etc.

The top part has magnet slots so that you can move it around when you need it and then place it back on top of the drawers for easy organization.

Comment & Rating (32)

(0/1000)

The print profile is no longer public
the drawers lack supports. otherwise nice idea
(Edited)
Support Issue
0
Reply
You just have to abilitate them in Bambu Studio :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The arrangement on the build plate has one very minor flaw, the print picks up the buildplate texture up on the wrong end to match visually. With the textured PEI plate the difference is quite big in visual finish of top and bottom part backs. I understand this is done to get rounder holes printing flat, still maybe there is a clever compromise 🤔 Otherwise a stellar design 💜
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Excellent design, for those who want neatly printed handles, it's recommended to open the file in Bambu Studio and enable supports, as printing in mid-air produces unsatisfactory results, my husband then had to melt them together with a soldering iron Otherwise, a top design, I'm thrilled ❤️ Thank you so much
Show original
0
Reply
Boosted
Super template, however, I had some problems with the handle 🤔 I unfortunately can't figure out what went wrong, I have the A1, I'll tackle the other print plate tomorrow and the box next week hoping it goes well 😅 Best regards and many thanks for the template ❤️
Show original
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed beautifully!Thank you.
0
Reply
The print profile is no longer public
parfait pour ma dremel
1
Reply
The print profile is no longer public
Excelent
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Good storage
Show original
0
Reply
Very pretty, unfortunately a little small for me; the drawer is smaller than my Dremel. I will try again by increasing the dimensions Congratulations
Show original
0
Reply
Merci
0
Reply