Adjustable graphic card holder bracket Geforce RTX

• The "new less support better version.3mf" is the latest version I recommend printing it.
  You don't need to remove the support from the inside because it won't be, just from the bottom which is two moments. Alternatively the middle of the rod is stronger.
  Print per object is set. The RTX has a layer height of 0.2 and the rod is 0.16 to get the threading right.
• New minimum height is 76 mm and new maximum height is 125 mm.
• On the pictures Sunlu PETG green.

• Check my other models: 

  https://makerworld.com/en/collections/6487987-gpu-holders

  
   

• Print per object is set in the profile.
• A support blocker is set on the threaded rod.
• The RTX needs the support, it takes 2 minutes to get the inside out nicely. You will need a large screwdriver, a small screwdriver and a small pair of pliers. Wait until the object cools down and be careful!
• The RTXis rotated 180 degrees on the Y axis, so the bottom becomes the front of the object, and so you don't see the seam in the middle of the rod as it is on the back.
• If you spray a little PTFE or similar lubricant inside the thread, the rod will rotate much better.
• I have tested it, I have printed several pieces.
• Adjustable between 85 and 126 mm.
• The model in the picture is made of Bambulab green filament.
• If you like it, please give it a like and a drop a review if you printed it.

Check out my other uploads and download and print them. AMD, ROG, TUF, Aorus, COD, Minecraft 

https://makerworld.com/en/collections/6487987-gpu-holders

!!! Make sure the print speed and temperature and cooling are set correctly for your printer and the filament you are using. And the build plate should be clean. !!!