painting stand with 608 bearing

Wish I found you sooner. Simple yet functional

nice model, good size to paint on and display on

printed great.

Perfect. Was looking for something that will print fast and not waste a ton of filament. Thank you very much!

lower fins were added to make it easy to turn

Thank you very much Marson1979, it's perfect

printing was good and fast enough, good bed adhesion. print was ok, needs instructions on assembly for beginners. I added a tab on the bottom so I can tell when it rotates 360 degrees, helpful when painting cylinders

Actually a good idea, but a bit wobbly and the bearing is not tight inside so it doesn't really grip and is useless, also the pin from the plate is too thin, I used some Teflon tape

Printed really well can recommend to use Super glue outside the bearing and the shaft but be careful to not put superglue on the moving part of the bearing that would be bad :P

Works perfectly 🔁 as expected. Smooth motion and solid build — super handy print! I use this stand every day for spray painting 🎨 Still holds up great despite all the paint buildup!