Search models, users, collections, and posts
Print Profile(1)
0.16mm layer, 3 walls, 30% infill
Designer
12 min
1 plate
Open in Bambu Studio
Boost
3
15
0
0
18
11
Released
Description
Boost Me (for free)
👉 If this project helped you, drop a boost - it keeps the ideas flowing! 🔥
Membership
Sell physical prints of my original MakerWorld models with an active Commercial Membership (subscription-based), and if you just want to support my work instead, you can tip me via Buy Me a ☕️
Join
This small part pushes the Lightning connector out by about 2mm, so you can charge the iPhone including a thicker case.
However, this still requires a small adjustment to the cable itself. There, the insulation has to be cut off a bit - best with a razor or cutter knife:
License
If you want to use this model commercially, please join my membership.
Join Now
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)