Shaman Mask - Free 3D Print Model

Search models, users, collections, and posts

norelem

Props & Cosplays>Masks & Helmets

IP Report

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.16mm layer, 2 walls, 15% infill

Designer

30.2 h

3 plates

4.6(11)

Open in Bambu Studio

Boost

267

657

341

Released

Description

Skull-faced zombie werewolf mask made on commission. think the character has been officially dubbed "Breynz"

Comment & Rating (26)

@JB_Design

Boosted

The perfect mask for my Halloween costume this year!

@GreeneHouse

Boosted

wow! the seams are invisible! very nice work! how’d you achieve that?

@JB_Design

Boosted

Sanding! Lots of sanding and filler primer.

@Sobczykov

hello did you change mask scale like fex 120%? or does it fit your head perfectly from the beginning?

@MakersJustMake

Print Profile

0.16mm layer, 2 walls, 15% infill

Only feedback is that some of the print is VERY sharp. otherwise perfect. Really enjoyed this print.

@GreeneHouse

Boosted

how did you get that finish? it’s really nice

(Edited)

@MakersJustMake

Replying to @GreeneHouse :

I layered several different light coats of off white spray paints, then washed with burnt umber and a mixes of black acrylic.

(Edited)

@mobbley930

how did you get the bottom jaw connected. Printed everything at the standerd size but the top and bottom aren't lining up.

@outlawcustom

Boosted

Print Profile

0.16mm layer, 2 walls, 15% infill

perfectly printed, perfect for my Halloween outfit, I am impressed

Show original

@Gonlie

What filament did you use and what infill percentage? Best regards

Show original

@outlawcustom

Boosted

I haven't changed anything in the print settings as far as I can remember, apart from the support settings, which I reset to the default values (Z distance) and used "Seamless" I printed with eSun PLA+ Bone White, and then painted it

Show original

@ulmerbarbar

Unfortunately, the front supports do not hold. After 2 attempts and different print plates. Too little adhesion. But I'll manage with some modeling clay.

Show original

@user_3454201954

Really nice model for the most part, since I have a big plate with the H2S I aligned and fused the parts together in studio to print all at once, sliced off part of the back, and put some negative rectangles as "slots" for an elastic band to go through. If I ever print the bottom jaw in the future I'll put some negative shapes in that too because as it stands there's no clear way to attach it otherwise

@PrintsNoir

Print Profile

0.16mm layer, 2 walls, 15% infill

the mask looks great. but the settings they have for the supports was a nightmare. they were impossible to remove. I HIGHLY suggest you change the top z distance on the support setting making it larger so its easier to remove the supports. I have to reprint the mask due to supports being stuck on the print.

Support Issue:the supports are way to snug to the model, please change the top z distance and make them easier to remove.

@mackan.gray

After gluing almost everything together, I can not figure out how to connect the lower jaw with the head, Any chance you could explain how it comes together?

@user_3055690457

I printed this but I'm a bit confused how it goes together as a mask. I printed with standard settings and not sure how to wear this with the bottom jaw