Search models, users, collections, and posts
Revised H-Pins for Gravitrax Pro
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.1 h
3 plates
Open in Bambu Studio
Boost
11
49
2
0
17
6
Released
Description
Update 1/4/2024
At the request of the Masked Marble, I've modified the original H-Pin so that it can be pushed horizontally rather than from above. Like their predecessors they pin together two adjacent Gravitrax Pro pillars. They can be used on the top or bottom of the pillar.
There are four variations: 24mm, 24.4mm, 24.5mm and 25mm.
In the 3Mf file there are three plates, Embossed, Plain and Reinforced. On the Reinforced plate I've provided the 24.4mm and 25.5mm versions.
Based on the feedback I've received the 24.4mm version appears to the best one.
I've eSun PLA+ in the photos as colour is quite close to Gravitrax's green and PLA+ wears a little better.
This remix is based on
The model does not exist anymoreLicense
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)