Search models, users, collections, and posts
XR30 G6/G5 Ecotech Radion Light Shade
Remixed by
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
16
61
0
1
113
0
Released
Description
Remix of the remix by @percula
I liked this design with the angled sides, because this minimizes the lightloss. The thing I changed was that I wanted the back wall, for less light spill. Also I made it 5mm taller to further reduce the lightspill to where I sit. Then I made the wall of the angled part a bit smaller because this is not really necessary and reduces the (long) print time.
With Cura slicer this print would take over 20h, but with Orca Slicer I reduced the print time to 13h.
I also printed this in esun PLA+ because my previous lights (Redsea ReefLed160) had a shade with the same material for 2 years and never deformed.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)