Seed Starter Set Self watering Funnel and Stamper

Hello everyone,

this time I have constructed a starter set for growing seeds and plants. This model is functional and not designed for beauty. Printed mine in ludicrous mode with super old filament cause it will just stay in my greenhouse outside.

The model fits on the Bambulab A1 mini. It is therefore a good idea to print several sets if you need more.

1. The plate is placed in the pots first. It helps to get the soil out of the pot in one piece after the cultivation phase or when repotting. This allows the seedlings to be transplanted in one piece.
2. The funnel helps to fill the individual small pots. Together with the tamper, you can easily get the potting soil into the pots.
3. To make the floor panel watertight, it must be coated with two coats of paint from the inside.
4. If possible, the water level should always be at least half full.
5. For repotting, the seedling can be pushed out through the center hole using a wire or skewer.

As always, have fun and be nice to each other.

EDIT 17.02.2025:

After a few reviews about the coins being a little too loose in the starter tray, I designed a grid to hold them in place. Takes 1 hour to print and 35 grams of filament. It has an opening in the front to easily pour water into the tray.

Here is a Avocadoboat I designed: