solid Ski Rack / Wall Mount / Ski Holder - Free 3D Print Model

Search models, users, collections, and posts

Downhill_Solutions

Hobby & DIY>Sport & Outdoors

IP Report

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

0.2mm layer, 4 walls, 15% infill

Designer

5.6 h

1 plate

4.9(40)

AMS 2 Colour - 0.2mm layer, 6 walls, 25% infill

16.7 h

1 plate

Open in Bambu Studio

Boost

188

652

776

445

Released

Description

Solid ski rack

Designed for 2 Carving Ski as close as possible in horizontal position.

Comment & Rating (54)

@user_4264498282

I really enjoy this rack but there is one major issue with the design. The angle of the top arm means that it's difficult to fit a normal sized drill (B&D 20v in my case) to drill the top screws in. It would work (at an angle) but I couldn't put enough pressure on the screws and stripped out a screw trying to use the drill. I had to pre-drill part of the hole, then hand drill the rest using a stubby screw driver (a normal length screwdriver didn't fit either!). Other than that, the design is elegant and came out flawlessly using PETG without supports. Comfortably holds a pair of 120mm (top in photo) or two pairs of nordic skis (bottom).

(Edited)

@MrHammer

Print Profile

0.2mm layer, 4 walls, 15% infill

Nice print

@EFFEG

Boosted

Print Profile

0.2mm layer, 4 walls, 15% infill

Just perfect! tks!

@user_2090812482

Printed with PLA, no issue, works greate. But must agreed with previous comment, Its problem to drill top screews due to arm angel.

(Edited)

@Kristofferli

Boosted

Print Profile

0.2mm layer, 4 walls, 15% infill

Just put them up. Did a little accent color thing on the sides, and they works and fit like a charm.

@Hausi86

Print Profile

0.2mm layer, 4 walls, 15% infill

@user_2775388478

Question, how did you get the skis to be vertical?

@mcmbrown211

They look like they're just resting on the ground and on the bracket, not being held up like other models.

@mcmbrown211

nevermind. they're just on the ground.

@user_2775388478

Oops, my bad! Very helpful to hold my skis though!

@Ccccchristopher

PLA filament works?

The designer has replied

@Downhill_Soluti

i‘m not sure, but you should print it with more infill/walls for more strength if you want to use PLA. i think this should work ;)

@Ccccchristopher

Replying to @Downhill_Soluti :

Thank you!

@michaellesko

Boosted

Great design.

The designer has replied

@Downhill_Soluti

thank you ☺️👍

@user_3711068636

Print Profile

0.2mm layer, 4 walls, 15% infill

200g of filament for each set seems a bit overkill, but it works fine.

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.