Bambu Lab AMS Desiccant Box / Silica Gel Container [EASY PRINT 30min] by cagriahiskali

cagriahiskali

3D Printer>3D Printer Accessories

GIF

Print Profile(4)

All

X1 Carbon

P1S

P1P

X1E

New Version v2

Designer

5.2 h

4 plates

5.0(45)

3 x 0.2mm layer, 4 walls, 50% infill

1.6 h

1 plate

4.9(10)

v2 vented walls

35 min

1 plate

4.9(7)

vented walls

34 min

1 plate

4.0(2)

Boost

172

317

143

1.2 k

909

Released

Description

IMPORTANT: You have to tune your slice settings exactly as shown on the pictures.

This time Box type of silica gel container. Much easier to print and less filament. Snap-fit lid. No screws. Only 30 min to print one box. Much aesthetic and no strings.

Comment & Rating (143)

@mark.mcmillan.c

Print Profile

New Version v2

Great print

(Edited)

@S147

Print Profile

New Version v2

Copied settings as per instructions and it printed perfectly, door is a snug fit, but goes in without any modification.

@shelby.eleanor

Print Profile

New Version v2

Very nice design, printed perfectly, fits perfectly in the ams. Tyvm!

@wintermelon

Print Profile

New Version v2

Nice design, can get really fine mesh if you increase the infill density

@devm33

Print Profile

New Version v2

Works great!

@Square3D

Print Profile

New Version v2

Printed without issues and works as it should. Thank you

@RealWorldPrints

The V2 boxes print great. the half moons i am printing now. What size magnets for the insets and holders? It's not mentioned.

The designer has replied

@cagriahiskali

Hi, Magnets should be 10mm in diameter and 3mm height. 10x3mm Thanks for the comment. Enjoy!

@chromos

Thanks for the print template. It's a nice simple design. Was great to snap out of. I have printed other dry boxes as well, but I liked this design the most.

The designer has replied

@cagriahiskali

Thank you for the comment. Please spread it out :))

@chromos

The print profile is no longer public

I was able to print the model with the profile very well. It's a good, solid drybox, there's just one small thing I would like. If only the fastening mechanism were a little better. Otherwise: simple, good, fulfills my wishes..THANK YOU

The designer has replied

@cagriahiskali

Hi; I considered your complaint. Try new version 2

(Edited)

@Filament_of_ima

The print profile is no longer public

Printed well for me without any problems. I used Slate Gray Sparkle PLA. Looks great with the matching box with the hygrometer mount. My only criticism is the fit of the cover, which I mitigated by securing with tape because one of them opened while i was removing it, causing the beads to scatter inside the AMS.