Search models, users, collections, and posts
Print Profile(2)
Version 2 w/ charge redirct 0.2mm layer, 3 walls, 20% infill
Designer
3.2 h
1 plate
ABS/ASA - 0.2mm layer, 4 walls, 20% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
7
6
1
2
42
20
Released
Description
This is a remix of ctjameson's charging funnel from Thangs. I modified it so it had smoother lines and added “Skywalker Roaster Charging Funnel” to the front.
Use this only when charging the roast. When the roaster is at temp, install the funnel, put in the beans, pull the bean release out. When charged immediately remove the funnel and replace the bean release. Please do not leave this in place during the roast.
Only use high temp filaments such as ABS, ASA, etc. Do not use PLA or PETG as they will likely deform from the high temps of roasting.
Enjoy your coffee and caffeine.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)