Wideband Global SATCOM (WGS) - Miniature Model

This is a remix of a WGS model I personally edited and made. The parts (specifically the Support Rod) might need some size tweaks to fit to your liking, however, they should be good to go now. Putting it together is straightforward. This was made using some OS pictures of the WGS and is not intended to be super in detail but just a fundamental representation . Depending on the Slicer used you will have to tweak the print settings to your own device. 

-----Note you will have to change the location of the hole on one of the radiators to sit flush with the hole for the Support Rod. If you print as is it will not fit properly as other parts of the bus will be in the way.----

 I used:

-PLA+

-.2mm Layer Height

-20% infill

-Supports enabled

I printed with a  Bambu Lab P1S with AMS.

Cheers!