Search models, users, collections, and posts
Angled mount for Eufy Wall Cam S120
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.8 h
1 plate
Open in Bambu Studio
Boost
17
41
6
1
114
60
Released
Description
Due to my relatively low wall, the Eufy S120 Wall Cam doesn't provide a clear view of the terrace directly below. To address this, I designed a 3D-printed mount that angles the camera downwards by 15 degrees. This adapter simply sits between the original mount and the wall during installation. For the upper mounting hole, a longer screw (approximately +30mm) is required.
Put the original plate agains the downward facing side (the side that sits on the print plate) to get best fit.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)