Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
110
302
15
5
384
254
Released
Description
Inspired by (but redesigned from scratch) Macbook charger cable organiser. Fits Dell's 65W USB C charging brick widely used across many different Dell laptops
Simple to print and fit - just slides over the charging brick. Easiest method is to push one end slightly in at a time like a seesaw motion. Will have to be placed off centre as the power cable comes from the centre-bottom of the charger brick.
The charger does not heat up much during use so printing in PLA is fine.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (15)