Search models, users, collections, and posts
Philips Hue Dimmer Switch Button
IP Report
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
12
51
8
1
48
16
Released
Description
Material Suggestions: While the model can be printed in various stronger materials, PETG is recommended from my side, as the hinge part is very small and fragile. This provides a balance of durability and ease of printing.
Printing Recommendations:
- Layer Height: 0.08 mm for a good quality
- Nozzle diameter: 2mm
- Infill: 20% for sufficient strength without excessive material use.
- Supports: Not necessary.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)