Blue Snowball iCE stand

looks great! I’ve always been annoyed by the tripod and I was looking for an alternative. the only thing I’ll say is that the screw is an issue. the one that comes with the snowball iCE is a little too long, and the hole in the stand is too big - I screwed it in and it literally just pulls right out of the hole. dunno if it’s because my model is 10 years old or something and there’s a different screw or what 🤔

Thanks for this model! It's sleek and takes up less space then the factory stand does. It also drops the mic 1,5cm compared to the tripod which i also like. The metallic "pole" from the factory tripod stand fits perfectly inside this model. I did have to shorten the screw a bit (5mm or so) to make it fit, but thats okay!

Thank you! I was just thinking of creating this! I needed a stand with a smaller height as the one it comes with is great but a little too high to put in front of my monitor. Printed this, ended up using the original stand screw and you can opt-in to use the smaller diameter washers but I didn't. Works amazing!

Easily better than the og stand, and great way to use parts of it for the print. Perfect