Search models, users, collections, and posts
Laptop Stand (Close to indestructable)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 20% infill
Designer
8.5 h
3 plates
Open in Bambu Studio
Boost
0
0
0
0
4
1
Released
Description
This is my take on the laptop stand. Made it a while ago and still use it. It should fit just about any laptop. THEORETICALLY, if you were to hit someone with this, they should break before this stand. (My lawyer told me to say that do not try this at home, especially if you're in America because the expenses might be too much).
Print Instructions:
- ≥0.2 mm
- ≥20% infil
- Any pattern
- ≥2 walls
I attached foam stickers to make sure the laptop doesn't get scratched. Might need sanding where the sides and connector attaches to make sure it is flush. 2 part epoxy recommended for maximum strength but be careful using it.
Happy printing.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)