Search models, users, collections, and posts
Needle File Handles | File Handle Replacement
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 35% infill
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
37
140
16
4
179
129
Released
Description
There are 3 different versions of these files handles with 3 different inside diameters (they are labeled 1-3 on the end of the handle). The needle files I made these for had a shaft outside diameter of 0.1135''.
1 = Very Tight - (honestly this is the one I like… even though they take a while to get on with some twisting involved)
2 = Tight - (this was likely the factory fit)
3 = Loose - (too loose for my application, but I figured I'd add another version for slightly larger shafts…. note you can always scale these up and down to fit your needs!)
I printed mine with no brim and PLA+… 35% fill but this was probable not needed.
Cheers,
Red Beard Ops
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)