Search models, users, collections, and posts
Filament feed tube support for the MP Select Mini / Malyan M200 / Prima P120
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
1
2
0
0
3
0
Released
Description
Since the Bowden connector used on these printer models are very prone to breaking, I designed this little clip that screws in to existing screws on the printer body. It will limit the range of movement of the filament feed tube, in an attempt to minimise wear on the connector.
All models that are based on the Malyan M200 series 3D printer could potentially benefit from using this.
Print Settings
Printer:
PrimaCreator P120 v4
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament:
White
Notes:
Simple little thing. Small bridge, but nothing that would need supports.
Post-Printing =============
- Unscrew one of the two screws used to fasten the clip (see thing image).
- Place the clip according to the thing image
- Put the screw back lightly in place, but don't tighten yet
- Unscrew the second screw
- Swing the clip in place
- Fasten both screws, don't tighten too much
- Profit.
Category: 3D Printer Parts
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)