Search models, users, collections, and posts
Square Cord Hole Cover
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
21 min
1 plate
Open in Bambu Studio
Boost
5
8
1
2
17
6
Released
Description
A simple square trim piece to clean up a square hole. A little super glue on the underside of the upper lip has worked perfectly to hold mine in place.
I made this to run cords out the bottom of my DIY printer enclosure. If you need to raise your enclosure a little off the ground for the cords to run, you can find the feet I made here.
The outer diameter of the lower section is 1.5"x1.5", so it should fit a square hole cut slightly bigger than that.
Comment & Rating (1)