Print Profile(2)
Description
Freya is a lightweight vase mode planter with a geometric diamond texture. The pattern creates a subtle play of light and shadow, while the tapered shape gives the planter a clean and modern appearance.
The model is designed to hold a standard plastic nursery pot, so the plant can easily be removed for watering. Each size includes approximately 3 mm of clearance on every side, helping the nursery pot fit comfortably without leaving an unnecessarily large gap.
The smaller versions can also be used as decorative holders for electric LED tealights. The diamond texture softly diffuses the light and creates a warm patterned glow.
Included sizes
The available sizes are divided into two multi-plate print profiles:
Standard build plate profile
Contains 17 separate build plates for nursery pots from:
5 to 21 cm / 2.0 to 8.3 in
These sizes are intended for standard-size printer build plates. Always check the required model dimensions before starting the largest versions.
Large-format profile
Contains 4 separate build plates for nursery pots from:
22 to 25 cm / 8.7 to 9.8 in
These versions require a larger build plate and will not fit on most standard 256 × 256 mm printers.
Each size is placed on its own clearly named build plate. Open the project in Bambu Studio and select the plate that matches your nursery pot.
The stated size refers to the maximum outside diameter of the nursery pot, including the upper rim. Because nursery pot dimensions can vary between manufacturers, measuring your pot before printing is recommended.
Printing
This model is designed specifically for Spiral Vase Mode.
- No supports required
- Fast and material-efficient
- One continuous outer wall
- Separate named build plate for every size
- Approximately 3 mm clearance per side
- Designed around a 0.4 mm nozzle
- Designed with a 0.42 mm outer wall line width
The scale is already built into every version, so each model remains at 100% scale in the project.
Important
Use a removable nursery pot instead of planting directly into the printed model. Vase mode prints are not guaranteed to be completely watertight.
Only use electric or battery-powered LED tealights. Never use a real candle or any other open flame inside a 3D-printed holder.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (0)