86-type switch - 1/64 car parking lot

💁🏻If you encounter printing problems, please don't rush to rate~🙏🏻

Leave a comment and upload photos 🫶🏻I will help you solve it immediately!

• Based on the following switch

(If you need other models, please leave a message, preferably with detailed dimension drawings)

• Detailed Installation Animation

(Please watch carefully before operating)
There are two ways to install the rubber bands (Steps 1-2)

01- Rubber Band Installation

Figure 1: Small rubber band / Figure 2: Regular rubber band

02- Securing the Car with Rubber Bands

Figure 1: Small rubber band / Figure 2: Regular rubber band

03- Assemble the model and the panel

Installation must involve inserting one end diagonally (because there's a stopper at the top edge)

04- Install the assembly back onto the wall

Align with the snap points and press firmly on the four corners of the switch (listen for the click as the buckle returns to place)

05- Place the small top decoration (can be glued)

🎉Finished🎉

If you encounter any problems during printing, feel free to leave a comment or send me a private message.
I will assist you in identifying the problem and providing a solution as soon as possible.🙏🏻

For faster processing, you can attach:

• Photos of the problem📷✨
• Filament brand and model🧵
• Printing parameters (layer height/temperature/speed, etc.)🔧

Let's work together to ensure you can complete your prints smoothly and with high quality.😊

💡Click to view《Print Quality Solutions》 to troubleshoot problems 💡

Ratings are very important to creators   You can read《Rating Guidelines》 then rate