Search models, users, collections, and posts
Desiccant Tray for Bambu Lab AMS
Remixed by
IP Report
Print Profile(3)
(High Quality) 0.08mm layer, 6 walls, 15% infill
Designer
1.8 h
1 plate
(SET OF 2) 0.12mm layer, 6 walls, 15% infill
1.8 h
1 plate
(Set of 4) 0.12mm layer, 6 walls, 15% infill
3.4 h
1 plate
Open in Bambu Studio
Boost
321
770
448
139
2 k
1.9 k
Released
Description
This was a well designed model but I didn't like that it was too tall to use with the stock cover. While I was shortening it I saw room for some improvements so I made the following changes:
- Reduced overall height just enough to fit the stock cover
- Added nubs to retain the desiccant tray cover in the tray
- Split the cover in half so you can leave the bottom cover in place and load even more desiccant
I super glued the bottom covers to the tray in my setup but it's not necessary.
Printing tips:
- Print everything with the flat side down
- Supports are not needed
- Use a fine layer height and outside/inside wall ordering for best fit and finish
Warning: If you print a third party profile you may not be getting the latest version or the highest quality print.
If you like this project, please don't forget to ❤ Like, ★ Rate, and 🚀 Boost!
Boost Me (for free)
If you find this model useful please consider sending a boost my way as it really encourages me to keep designing.
* Some of the links above may be affiliate links
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (448)