Blue I Am Sour - Grumpy Bear NoAMS

🌞 Here's another small model for you before the summer break! 🌞

💙 Here comes the Blue "I'm Grumpy" Bear – this time as a NoAMS version! 💙

Yes, I know... this pose already exists. 😄 But so far only as an AMS and OneColor version. Now everyone without AMS can be happy too!

⚠️ IMPORTANT – Please read before the grumpy bear gets even grumpier! ⚠️

Assembly requires a bit of finesse in a few places (especially with the **eyes** and the **raindrops**). Sometimes you need to apply a little pressure and find the right angle for everything to snap into place cleanly. If it really doesn't work, you might want to scale the eyes down a bit.

UPDATE 12.07.2026 : There is now a print profile with slightly smaller scaled eyes that should make assembly a bit easier if anyone has problems.

So please don't lose your patience or leave a hasty bad review just because it didn't pop on the first try. 😉 A little patience is simply part of 3D printing!

The model was printed entirely with **Bambu Lab filament** on an **A1**. Depending on the filament, printer, and calibration, the parts may fit a bit tighter or looser. A touch of glue also won't hurt in some places.

Assembly should be manageable for everyone – unless you were truly born with two left hands... then it might be a challenge. 😅

Print Settings:

• 📏 Height: 140 mm
• 🧱 Layer Height: 0.16 mm
• 🪛 Nozzle: 0.4 mm

The **Fuzzy Skin** is of course also included – but **only in the 3MF file**. (Yes, really **only** in the 3MF! 😄)

The support is easy to remove. As always: a clean print bed and a well-calibrated printer are half the battle.

Of course, there are two variations again:

• ✅ Profile **by object**
• ✅ Profile **by layer**

If you like my work, I would be thrilled to receive a **Like**, **Feedback**, or a **Boost**. This supports me and motivates me to design even more grumpy bears for you.

Have fun printing, crafting, and with the little fight with the raindrops! 😁🐻💙